UltraStik control panel questions

Show us your cabinet, control panel, or clever mod. Tell us what you did and share how you did it. Bask in the glory!
Post Reply
gree0245
New Member
New Member
Posts: 1
Joined: February 20th, 2014, 1:30 pm

UltraStik control panel questions

Post by gree0245 » February 24th, 2014, 12:02 pm

Greetings. I'm working on my first MAME cab and recently purchased two UltraStiks. I was planning on using them in "input mode" and wiring the buttons to the sticks directly for my control panel. It is my understanding that the computer will then read the UltraStiks like two separate control pads if I wire it that way. So if I set it up that way how do I wire the "administrative" buttons for the control panel? Do I still need to buy a control interface for the 7 or so "administrative" buttons on the control panel? Not that I mind doing so, but I was just questioning whether this was the best way to go. I'd appreciate your opinions.

Post Reply